Fog Question

by **Ruski** » Wed Mar 28, 2007 7:50 pm

ok so my fog got water in it. but i fixed the problem. but now encountered another problem. the metal thing inside the fog that goes around the bulb it kind looks like a diamond , it got bent during the process and now i cant unbend it.. So i was wondering if i can just remove it ?? and will it cause any problem with light out put?? or heating the plastic ??
Thanks guys :drinking:

by **CamryOnBronze** » Wed Mar 28, 2007 8:26 pm

im not positive, but I believe it will either hurt output because that is a reflector, or it will increse output because the cap is gone... i think it is the first guess though if Im not mistaken.

by **lilm** » Wed Mar 28, 2007 9:16 pm

decrease output

by **woa_its_j3ff** » Wed Mar 28, 2007 9:55 pm

it'll decrease output. actually i had the same problem when water got in my fogs. i used a really log needle nose plier to fix that.. hope it helps some.

by **Ruski** » Thu Mar 29, 2007 9:06 am

^ thanks guys, o jeff thanks i might need to change out blinker and fog fluid to get the nice light out put again... FTMW :drinking:

by **woa_its_j3ff** » Thu Mar 29, 2007 11:28 am

Ruskimafia wrote:^ thanks guys, o jeff thanks i might need to change out blinker and fog fluid to get the nice light out put again... FTMW

how did you know. use synthetic oil base because the water and oil wont mix then which means itll all drain out nice and easy. i got mine for 5.99 . :drinking:

by **CamryOnBronze** » Thu Mar 29, 2007 12:49 pm

had you guys never heard the blinker fluid joke until yesterday or something? Its in every single thread I have thread in the past 24 hours :lol:

by **woa_its_j3ff** » Thu Mar 29, 2007 12:51 pm

^ i've heard of it among a few others. my flux capacitor went out yesterday too.

Fog Question

Fog Question

Who is online