by hskrsolara » Fri Apr 08, 2005 9:17 am
If it sounds like something is grinding in there, it is probably your regulator. Thats how mine sounded and the grinding was actually caused by the regulator cable getting off the pulley and banging around in the door. I would reccomend just replacing the whole regulator so you dont have to worry about it anymore. On the door, there are several clips around the bottom, and also 2 screws on the bottom. Right next to the door hinge there is another screw with a cover on it. Also remove the screw in the door handle assembly, you will see a little square cut out to open to get to the screw. Two left, there is one in the bottom of the small cup/handle used to close the door. Then you will need to take out the switch panel and below there is the final screw, holding the whole panel to the door. Take this out and voila! Sorry if this seems really long and confusing, but actually the process is very easy!
99 DWP SEV6 5spd 6.5psi+Meth, Tein+Tokico, EricSol+Brembos+EBC, OBX Headers+OBX 3" Exhaust, Supra MAF & 330cc, Spec 2+, Fidanza, TRD lip kit, Injen+Ext, Optima Red, Infinity 60.5+693.7i, 2 Kappa Perfect 12 VQ's+iPod+JVC DVD...etc
