messed up turn signals

[AzN_DrAgoN48]

so just recently my turn signals stopped working. but i checked the relay and i check the fuse and they are all fine. sometimes they work when i start my car in the morning but then 5 mins into a drive they shut down again. sometimes when i hit the hazards they would start working again. the hazards always work by the way. any ideas?

[Fenix]

Loose connector, maybe? or could it be the light bulb itselt? If you haven't done anything to the electronic system recently such as installing lights, modifying your dashboard, installing your stereo, so on, then it must be the problem with the signal light.

Just take it out and check it.

[AzN_DrAgoN48]

i did do all three of those. how do i check the connection? i installed hids, a stereo and i did new lights to the dashboard. where should i start to go in?

[Yanks0114]

sounds like the hazard light connector is loose. Check that first(you would have had to remove it when u installed the stereo)

[AzN_DrAgoN48]

the hazards are fine, they always work. however the actually turn signals bar doesn't work. whenever i press down nothing happens and when ever i push it up it doesn't work

[Solorange]

I had this problem with my camaro. The problem was the flasher. The hazards on my camaro use a different flasher, than the turn signals. That may be why they work fine. Im new to toyotas, but that could be something to check into.