Injectors 330cc upgrade - HELP!!!

[that1mexguy]

Hey guys, have any of you got these installed??? I got a set that Gabe (trd4life) was selling a while back and i just got a chance to finally take my car to the shop to get some other stuff installed so i asked them to get these in as well..... well the guy from the shop just called me and he's telling me that they dont seal properly and he doesnt think they'll fit so I was wondering if you guys have done this before and if there is a trick to it, otherwise i think i'm screwed $175 (plus the labor from the shop). Any help greatly appreciated, thanks

[Ian]

I bought them too, but never installed them, so I don't have any useful information specific to your question.

On another note, I was told if I use the Supra injectors that I will have to lean the ratio a little bit because they flow so much (330cc). I planned on using the Split Second unit from URD, but I haven't done that yet, so I haven't used them. I wonder if I would have to lean the ratio if I used the injectors from URD which flow 305cc I believe.

I'm running 6lbs. boost.

Good luck.

[SC V6]

you need new seals.. there is some seal or something that needs to be ordered.. I had the dealer do those.. and they had no problems

[that1mexguy]

Hey man, do you know if it was the o-rings at the top, bottom, or both? anyone?

[Turbosolara]

the shop must be moron....you cannot reuse o-ring. you suppose to replace o-rings everytime when you open it, otherwise it will leak fuel

[that1mexguy]

well i assumed it was o-rings since i know of other stuff that use some sort of o-rings to seal leaks, but hey, they never called me back so they must've figured it out.... thanks all

[michaels artic frost]

that1mexguy,

Was this the project that you were referring to bro?

-M

[that1mexguy]

that1mexguy,

Was this the project that you were referring to bro?

-M

LOL uh .. not even close .. but nice try... i'll kepp ya updated