Help with installing Injen intake...

[ThatVietGuy]

So I got my Injen today and I tried installing it ASAP. I got through most of it until I hit the hose that goes from the top of the motor (A) to the last plug on the intake (B) (I assumed that the stock hose would work )

I need to know what size hose (length, diameter, etc.) that I need that goes from A to B...

Thanks in advance

[PhreakdOut]

I assume the OE hose was too large?

You could use a wormgear clamp on the Intake side just long enough to run to the parts store and get the smaller diameter hose. (Should be less than $2.50 for a universal hose.)

[ThatVietGuy]

OE hose was too short

Thanks for the input.


P.S. No worries about transport, I've got two of the family cars to use

[Ford_Fixorrepairdaily]

go to a local car parts store and if youre desperate go to autozone or something. I got mine from a shop for like 5 bucks. I dont know the exact size, but you can return it if it doesnt fit lol

[ThatVietGuy]

Also, is it necessary to put that black sleeve back on? The sleeve that was covering part of the OEM hose?

[SleeperSolara]

Also, is it necessary to put that black sleeve back on? The sleeve that was covering part of the OEM hose?

You can just leave it off.

[562solara02]

jus go to kregen autoparts and get a hose jus take the stock 1 so u get the right size its only like 2 bucks u cut it urself see if u bought mine it would of came with it (a 2 dollar value) lol

[ThatVietGuy]

^^ LOL

Care to part out the hose? j/k :p

[ThatVietGuy]

Got the hose today from Napa for $2.58. And to think I was about to go to Pep Boys and pay $6 for a pre-cut hose