by CASTRO » Tue May 02, 2006 9:58 pm
rich, check your PM...
i also forgot, to have PERFECT adjustments on spring preload (X1) ride height is adjusted with (y) distance. Just measure and make sure both fronts (X1) lengths are equal. I talked about it in detail in the PM. Same goes to the rear, but they are not the same as the front and rear springs are different rates and lengths.
Adjust the (X1) distances when it is off the car.
After it is all done and installed on the car, the (Y1) can be adjusted to the height of your liking.
If i confused any, I just want to say that the only thing that PDF says is X1&X2 has to be only set once, and done right.
To adjust the height, you undo the bottom lowest perch and twist the entire housing while keeping the spring adjustment length the same aka (X1-X2)
i also forgot, to have PERFECT adjustments on spring preload (X1) ride height is adjusted with (y) distance. Just measure and make sure both fronts (X1) lengths are equal. I talked about it in detail in the PM. Same goes to the rear, but they are not the same as the front and rear springs are different rates and lengths.
Adjust the (X1) distances when it is off the car.
After it is all done and installed on the car, the (Y1) can be adjusted to the height of your liking.
If i confused any, I just want to say that the only thing that PDF says is X1&X2 has to be only set once, and done right.
To adjust the height, you undo the bottom lowest perch and twist the entire housing while keeping the spring adjustment length the same aka (X1-X2)
97 Camry XLE S/C V6 -- 07 "New Formula Red" S2000 -- 07 "Milano Red" Fit Sport
-
CASTRO - SolaraGuy Semi-Pro Racer
- Posts: 2032
- Joined: Fri Feb 27, 2004 12:35 am
- Location: Elk Grove/Sacramento Cali 916 Area