Fron Turn Signal HELP!!!!

[Sikh1MZFE]

I purchased this http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=009&sspagename=STRK%3AMEWN%3AIT&viewitem=&item=190105832313&rd=1, and when i installed it my right friont signal started blinking faster then my left, my left stil lhas regular stock bulb in it. Well Its blinking like 3x the speed it should be blinking. WHY IS THAT??? did i blow a fuse, but if thats the case why is th bulb still blinking, im confused, please help!!!!!
thanks

[Midias]

I swear these kids today don't even know the difference between a LED and a tungsten filament bulb. The LED bulb had remarkably less resistance and therefore is causing your relay which is probably electric and relays on a capacitive circuit to work is now charging and discharging faster. You need to add some series resistance, or just ditch the damn led signals and use a regular bulb.

[Ruski]

or get blinker fluid.. it might need a flush

[lilm]

HAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHHA


in non car guy terms..........the little lightbulb you bought(led) uses a whole lot less elcktrickty(electricity) than the normal bulb(filament) causing the light to blink faster.....just change both lights to led's and you will be fine

[woa_its_j3ff]

or get blinker fluid.. it might need a flush

synthetic blinker fluid i would assume. that goes directly into the flux capacitor

[iinokturnolii]

come on guys... that blinker fluid thing... is getting killed... it was funny the first 100,000 times... but yeah.... you get the point...


Sikh1MZFE... i think "load resistors" will do the trick...
http://frickinbrite.com/catalog/product ... cts_id=113

[Ruski]

^^ Party Popper !!!! It wasn't used in a while so i had to bring it up

[iinokturnolii]

^^ Party Popper !!!! It wasn't used in a while so i had to bring it up

nah ... aint trying to party poop on yall little parade ... but Jeff is just killin it... "i think he overfill his blinker fluid joke?"