going to Dyno this thursday
Posted: Tue Dec 18, 2012 10:10 amHey So Cal people, i have an appointment at Churches on this Thursday at 12. going to be base lining my 3MZ with 1MZ electronics. (non VVT)
Page 1 of 1
Posted: Tue Dec 18, 2012 10:10 amRe: going to Dyno this thursday
Posted: Thu Dec 20, 2012 10:02 pmHere are the results
Re: going to Dyno this thursday
Posted: Thu Dec 20, 2012 11:43 pmThose are some bad ass dyno number for n/a. Toyota never used a 5speed on a 3mz, now
For a boosted 3mz. You should hit 400whp with a trd s/c and 10.5psi.
For a boosted 3mz. You should hit 400whp with a trd s/c and 10.5psi.
Re: going to Dyno this thursday
Posted: Fri Dec 21, 2012 5:45 pmFinally we know what to expect from a 1mz/3mz hybrid. Good numbers!
Re: going to Dyno this thursday
Posted: Fri Dec 21, 2012 7:36 pm^^^ no not 1mz/3mz engine, just 3mz engine with 1mz electrical.
Re: going to Dyno this thursday
Posted: Sat Dec 22, 2012 1:03 amyeah greg is right, my hybrid engine started knocking. i havent tore it apart yet to see why. so i had swapped in a full 3MZ but its got the 1MZ intake manifold on it and im using 1MZ computer (non VVT)
Re: going to Dyno this thursday
Posted: Sat Dec 22, 2012 5:46 pmDo you happen to know where your AFR levels were?
Re: going to Dyno this thursday
Posted: Tue Dec 25, 2012 8:50 amyeah rich as hell. it was dipping into the 10s by about 4000 RPMs.