[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: date(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSK/3.0/no DST' instead
[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: getdate(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSK/3.0/no DST' instead
SolaraGuy.com • View topic - DIY: OBX Headers Installation
Page 3 of 3

PostPosted: Wed Aug 19, 2009 11:05 pm
by 20SoLaRa02
GREAT TUTORIAL. I was able to finally complete the job after 4 days of work. The reason it took me so long was i had to keep going out to buy parts and then i didn't even have the egr tube. Also i'm not the best mechanic. I almost gave up at one point. If i had to do it all over again i'd probably take it to a shop, but that's just me.

For anybody who is going to attempt this DIY it is very possible to do by yourself. Just make sure you have all the exact tools mentioned.

Thanks for the tutorial

PostPosted: Mon Feb 01, 2010 7:11 am
by MillerTime12oz
Great Tutorial. What does it mean if the CEL light comes on. If I installed these would I have to put a cat on or would it still run ok? How would I get by without installing a cat?

PostPosted: Mon Feb 01, 2010 8:13 pm
by EricSol
You will have to install a cat or a O2 simulator to keep the light off.


MillerTime12oz wrote:Great Tutorial. What does it mean if the CEL light comes on. If I installed these would I have to put a cat on or would it still run ok? How would I get by without installing a cat?

Re: DIY: OBX Headers Installation

PostPosted: Sun Jul 01, 2012 6:40 pm
by 1kdude
Thanks for a very helpful tutorial. Does the OBX Y pipe fit on the stock headers? I have a Greddy cat back on now..

Thanks again.

Re: DIY: OBX Headers Installation

PostPosted: Sun Jul 01, 2012 7:45 pm
by 1gSE
1kdude wrote:Thanks for a very helpful tutorial. Does the OBX Y pipe fit on the stock headers? I have a Greddy cat back on now..

Thanks again.


No. The factory manifolds are a 2 bolt design, OBX is 3