Need help on knock sensor re-wire
I have a 330 code..bank 2. So I assume I would do the OPPOSITE of this tutorial:
"If the code that ur sensor was throwing was comming from the bank #1, which is the rear sensor, then what u have to do is cut pin #27's wire, give enough slack to each side of the wire because u will need to expose the wire underneath the plastic of the wire. then take off some plastic cover from pin 28 but do not cut that wire, just expose the wire and connect pin 27 to it, firmly, the part that is comming from the ECU, not the wire that leads to the engine bay."
So, I would splice wire 28 INTO the intact 27..right?
Just want to confirm this.
Thanks
RON
"If the code that ur sensor was throwing was comming from the bank #1, which is the rear sensor, then what u have to do is cut pin #27's wire, give enough slack to each side of the wire because u will need to expose the wire underneath the plastic of the wire. then take off some plastic cover from pin 28 but do not cut that wire, just expose the wire and connect pin 27 to it, firmly, the part that is comming from the ECU, not the wire that leads to the engine bay."
So, I would splice wire 28 INTO the intact 27..right?
Just want to confirm this.
Thanks
RON
-
RON - SolaraGuy Driver
- Posts: 517
- Joined: Sun May 03, 2009 2:15 pm