[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: date(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSK/3.0/no DST' instead
[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: getdate(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSK/3.0/no DST' instead
SolaraGuy.com • View topic - Engine won't start, SC install
Page 2 of 2

Re: Engine won't start, SC install

PostPosted: Wed Dec 12, 2012 12:14 pm
by alltrac92
There should be two ground wires attached to the nose.

Re: Engine won't start, SC install

PostPosted: Wed Dec 12, 2012 12:30 pm
by Gregtrd
You're missing the grounds that go on the back of the supercharger. I'll take a picture when I get home of the ground that I'm talking about

Re: Engine won't start, SC install

PostPosted: Wed Dec 12, 2012 1:12 pm
by Bostonlara
Ok, I know on the stock intake there in a ground on the left side of the manifold and one in the rear facing the fire wall. So I put the left one on the nose and the rear one on the rear were it was originally attached but just bolted to the supercharger.

I'll wait for the pic Greg, thanks

Re: Engine won't start, SC install

PostPosted: Thu Dec 13, 2012 12:57 am
by Gregtrd
Heres the two grounds that im talking about on the rear right side if the engine.
Image

Re: Engine won't start, SC install

PostPosted: Thu Dec 13, 2012 10:12 am
by Bostonlara
Thanks Greg. I'm on my way home now so I'm going to check the grounds.

Btw that's some picture you took. I'm guessing that engine is on a stand? No way you took that from inside the bay lol

Re: Engine won't start, SC install

PostPosted: Thu Dec 13, 2012 11:55 am
by Bostonlara
THAT WORKED!!!

I had to recheck all my vacuum lines because it kept stalling, fixed the lines and took her for a test drive!!!!

noticeable power increase, but when i go WOT it feels slow then the boost kicks in, maybe i need to tighten the belt some more. i got my boost gauge but its not hooked up so i'll do that tomorrow to see how much boost im using.

thanks everyone!!!

Re: Engine won't start, SC install

PostPosted: Thu Dec 13, 2012 3:58 pm
by Gregtrd
I guess I am the top tech of sg J/K ladies, do you have the ebc hooked
Up? If so then your boost will kick in around 30mph.

Re: Engine won't start, SC install

PostPosted: Thu Dec 13, 2012 11:20 pm
by Bostonlara
i do not have the ebc hooked up. i have the bypass valve hose routed to the barb that it right below it.