PAC TRUNK LOC
Tonight I installed a sub and amp to the factory head unit using the PAC TRUNK LOC. This LOC has a trigger built into it so it will turn the amp on once it senses voltage over the speaker wire. My problem is that it seems that there is constant voltage over the speaker wires even when the factory head unit is turned off so the amp comes on when I turn the ignition on. I tested the factory speaker wires and there is 6volts when the head unit is on and when it is off. Also when the ignition is switched off I get a loud humming noise back through the amp and sub. I went through the wiring several times and even rewired it thinking there was a short somewhere. Anyone have any suggestions???
- Solara05
- Just Licensed SolaraGuy
- Posts: 9
- Joined: Mon May 02, 2005 4:01 pm