3rd led brake light

by **iinokturnolii** » Wed Jun 20, 2007 3:51 pm

Where to get'em thread: http://solaraguy.org/viewtopic.php?t=33864

by **michaels artic frost** » Wed Jun 20, 2007 3:54 pm

Congrats and props!!!

-Michael

by **---CAMRAZY---** » Wed Jun 20, 2007 4:13 pm

Sweet Van!!!

by **Astro** » Wed Jun 20, 2007 4:15 pm

Those are lookin' real good! Great job

by **ClassySolaraGuy** » Thu Jun 21, 2007 1:20 pm

Clean! Looking good!

by **anttarz** » Thu Jun 21, 2007 1:28 pm

looks sharp... matches up well with the gen 2.5 LED tails

by **PXLpainter** » Thu Jun 21, 2007 1:38 pm

Uh... is that "breaklight" or "Brake Light"? :lol:

Lookin' good though! :up:

by **Biggi_e** » Thu Jun 21, 2007 2:08 pm

looks pretty sweet! great job!

by **cklinh** » Thu Jun 21, 2007 2:10 pm

Cool. Looks much easier than the way I did mine (and much straighter).

Hey Van, are you going to the BOS meet?

by **Biggi_e** » Thu Jun 21, 2007 2:10 pm

would you be able to do a write up these? i would like to do this mod also if possible. thanks

by **SleeperSolara** » Thu Jun 21, 2007 3:15 pm

Looks bad @$$ man.

by **iinokturnolii** » Thu Jun 21, 2007 3:20 pm

PXLpainter wrote:Uh... is that "breaklight" or "Brake Light"?

Lookin' good though!

you got me! LOL!!!
i just changed it... heheheh

thanks for the comments guys! much appreciated.

biggie: its pretty easy. all you need is a little soldering skill... cause it didnt come with any wires attached.

so, all you really need to do is solder 2 wires. one positive and one negitive onto the ends of the LED strip.

here we go:

take out your panel that covers your back speakers. (i think most of you guys know how to get back there). remove the red plastic piece from the clps. cut off the old bulb harness. then i used some electrical tape to kinda hold the LED strip in place (in the middle) against he red plastic piece. cut off extra electrical tape. use some wire connectors to connect the wires. make sure you find out which wire is positive or negitive. get a 9 volt battery and do a quck test before you install. then just pop the red plastic piece and LED strip back into the clips. the LED strip should be pretty snug against the red srtip. then reinstall everything back.

i'll try toget some pics up later.
peace out!

by **Biggi_e** » Thu Jun 21, 2007 4:25 pm

sweet thanks Van, pics would def. help tho!

by **iinokturnolii** » Thu Jun 21, 2007 9:15 pm

cklinh wrote:Cool. Looks much easier than the way I did mine (and much straighter).

Hey Van, are you going to the BOS meet?

whats up chung. nah i cant make it... had other plans for that weekend.

3rd led brake light

3rd led brake light

Who is online