by Akfahad » Fri Apr 06, 2007 4:52 pm
Got it to work....for the '99 Solara:
click the link above, click Gen 4 Toyota Camry Factory Repair Manuals, click Electrical Wiring Diagrams and go to page 67. In the middle of the electrical diagram you'll see Bank 1 Sensor 2 (exhaust O2 sensor). One wire is pink and black, this is the heater function for the O2 sensor. The other wire is black, which is the actual O2 sensor. This is the wire you want (mine was black with two little silver strips around it spaced a couple of inches apart). The wire is under the E8 (B) diagram, which is found on page 77. The pin you'll be cutting is pin 8 and the actual connector going into the ECU is white (Some are white and some are black). The tricky part of this whole thing was that I was expecting my ECU to look like the picture, but it was actually upside down. So instead of seeing pin 8 on the top left side, in the second hole, it was the bottom left side in the second hole. Working fine and thanks for the help everyone.
Last edited by
Akfahad on Sun Apr 08, 2007 2:49 pm, edited 1 time in total.