Pioneer tweeters

by **Taido** » Tue Aug 11, 2009 10:36 am

Put these in last night.

Still need to tweek the sound settings...

by **yaddadaimsayin** » Tue Aug 11, 2009 10:43 am

whaddya think about em?

by **Taido** » Tue Aug 11, 2009 10:56 am

Compared to the stock tweeters, I can actually tell that they're there. xD And I think I did a pretty clean install.

by **GzNutz** » Tue Aug 11, 2009 2:03 pm

^ Yeah, that looks very clean. What was the difference in size between the old and new?

by **wkbrdr91** » Tue Aug 11, 2009 2:17 pm

Why didnt you just put it into where the stock one was instead of drilling a hole for it?

by **iinokturnolii** » Tue Aug 11, 2009 6:54 pm

i think it woulda looked cleaner on the door...

http://www.youtube.com/watch?v=PELNvr0wiiQ

by **Taido** » Tue Aug 11, 2009 9:50 pm

The stock tweeters were 2 1/2". These are 7/8". The stock tweeters also had a mounting bracket. I didn't feel like trying to make a bracket and make it even more of a pain trying to work in that cramped up space against the windshield. Also didn't have a drill. Used a butane lighter and a knife when I got closer to the edge. lol :onfire:

And some door tweeter set-ups do look good, but not this combo.

by **LEE337** » Tue Aug 11, 2009 10:53 pm

*looking in the background*

Are you at a bike show? Looks cool!!!

by **Taido** » Wed Aug 12, 2009 12:20 am

No that's the parking lot in front of my dorms on base. Like 15 guys living in the dorms have bikes.

by **kpxboi0619** » Thu Aug 27, 2009 5:41 pm

I got the same one but I put mine in... instead of drilling another holes

by **Ruski** » Thu Aug 27, 2009 6:25 pm

i drilled holes for mine in the same spot, you would have to Fab a bracket to put them inside and there really is no room to work with

by **Maniax** » Wed Mar 24, 2010 10:11 am

How do you get to taking off the cover for the tweeters?Do you have to take the whole dash off?

by **Black Bob** » Wed Mar 24, 2010 10:47 am

^^^^I heard they just pop off, but I'm quite sure it doesn't require removing the whole dash. The door and rear deck speakers are another story....

by **Aotoyota** » Thu Mar 25, 2010 9:53 pm

could have saved he factory grille by bending a piece of backstrap to make a custom mount for your tweet. then mount the tweet on top

by **Taido** » Sat Mar 27, 2010 2:14 pm

To take the cover off, just take a flathead screwdriver with tape on it and pry it up. And just a heads up, for rewiring, it's easier to drop th new speakers' wires down beneath the dash. Practically NO room against the windshield even if you pull the stock wiring all the way up, in doing so you also risk pulling the wire apart cause partway down it's just taped and wrapped to another section of wiring.

Pioneer tweeters

Pioneer tweeters

Who is online