1mz wont rev needs help
hey guys im new on here ......
i have a mazda 626 i have fitted a 1mz to from a camry i have wired in the factory ecu and am having problems with it
it will start and run ... will idle sooooo smooth ..... but when i go to rev it it just dies in the arse ....
i have taken it for a drive around the block and i can only give it light throttle ... or it will die till i take my foot off the throttle
i have fitted 3vz fuel rails to it so i could get a return line and a pressure reg.
i am useing the factory camry maf and airbox .
i have removed the egr valve from the inlet and had to move the o2 sensor in the back bank to make clearence to the stearing rack.
i have removed the power steer pump and the a/c and just have a short belt to the alt.
the motor was from an auto car and so waas the loom and ecu
i have fitted a manule box and fly wheel from a 3vz as we dont get verry many manule 20series camrys over here.. and i have removed the auto ecu and i am not running the ac or airbag ecu but i am running the imobiliser module and key to get it to run.
i havent hooked up the speed sensor but i dnt think that gose to the ecu .
if i disconect the maf it dose the same thing .. so maybe it is stuffed >>>>???
i carnt think of anything else ...
i can prob take a viedo clip of the car running and what its doing ... if you guys no this problem and can help would be verry much appreciated ..
thanx in advance .......
i have a mazda 626 i have fitted a 1mz to from a camry i have wired in the factory ecu and am having problems with it
it will start and run ... will idle sooooo smooth ..... but when i go to rev it it just dies in the arse ....
i have taken it for a drive around the block and i can only give it light throttle ... or it will die till i take my foot off the throttle
i have fitted 3vz fuel rails to it so i could get a return line and a pressure reg.
i am useing the factory camry maf and airbox .
i have removed the egr valve from the inlet and had to move the o2 sensor in the back bank to make clearence to the stearing rack.
i have removed the power steer pump and the a/c and just have a short belt to the alt.
the motor was from an auto car and so waas the loom and ecu
i have fitted a manule box and fly wheel from a 3vz as we dont get verry many manule 20series camrys over here.. and i have removed the auto ecu and i am not running the ac or airbag ecu but i am running the imobiliser module and key to get it to run.
i havent hooked up the speed sensor but i dnt think that gose to the ecu .
if i disconect the maf it dose the same thing .. so maybe it is stuffed >>>>???
i carnt think of anything else ...
i can prob take a viedo clip of the car running and what its doing ... if you guys no this problem and can help would be verry much appreciated ..
thanx in advance .......
- soul australia
- Just Licensed SolaraGuy
- Posts: 15
- Joined: Mon Nov 15, 2010 3:53 pm