Clutch & Flywheel install

[S99Solara]

flywheel - http://www1.autozone.com/servlet/UiBrok ... 13e7c2.jsp

clutch - http://www1.autozone.com/servlet/UiBrok ... 13f5b1.jsp


guys is this enough information to DIY?

i'm putting in a clutchmaster stage2 + fidanza flywheel

[PASolara]

Well thats pretty general i noticed it said u had to remove the engine witch u do not. Actualy If u do it right u dont even have to remove the tranny. I have done my clucth my self 3 times in my drive way. The hardist part will be getting the passenger side axle out. U can just slide the tranny off enough to replace the clucth and flyhweel. Saves alot of work of dropping the sub frame

Good luck let me know if u need any help

[S99Solara]

yeah come over to my place and give me a hand! =) j/k

do i need any special tools for this job?

[PASolara]

LOL if i lived close i would give ya a hand. No u dont really need any special tools just basic tools and swivel and extentions just remember to clean the clucth and flywheel with brake cleaner when u install it. Oh and use tread Lock on flywheel and bell housing bolts just for safty sake. .

umm thats about it just ask me if u have any qestions.

P.S oh yea just unbolt the slave cylinder not the lines. Saves u from having to bleed the clutch (witch is a little Bitch )

[S99Solara]

what is the estimate time to get this job done?
when i did my water pump + t-belt it took 6hrs and i was told clutch job will take a lot longer.

btw: where are you located at? i'm in PA

[dan99solara]

i hate installing clutches im paying to get mine done...

[S99Solara]

expect to pay at least $300+ for the labor

[S99Solara]

PASolara - can you write me up some shortcut instructions?