by JoeB » Tue Oct 19, 2004 7:54 am
That's correct, if you are running too rich, the excessive gas cools down the combustion chamber/exhaust out. Too lean it will run hot. The article was great but mostly focused on diesel which is a different principle. My readings are similar to Mike's, at idle it's around 800-900, normal load is around 1200when I'm really getting on it, I see as high as 1300-1400 but never over that. It sounds like diesel might need to run a little cooler than regular gas. The general rule for regular gas is not to excede 1600. Keep in mind this is dependant on where exactly you mount the EGT probe. The further down the exhaust you mount it, the cooler your base reading will be.
Trying to analyze it will drive you mad! The car's ECU keeps the car running at 14.7:1 a/f right? So if I have my a/f tuned to 12.5:1 under load, why would my EGTs go up when I gave it more fuel? The only thing I can think is there is a LOT more energy/power and with that extra power there will be heat. I don't think you can use the EGT as an identical replacement for an a/f meter for this reason. It's great to monitor a/f, don't get me wrong but don't expect to just get 1 reading accross the board. It's still a GREAT tool to watch for dangerous conditions. Especially on the top end! -JoeB