Springs

[SirMacDaddy]

So just recently i bought the gen. 2 rims for my gen 1 and i put them on with some low profile wheels...225/45/17s and there is a lot of space between the wheel and the wheel well. i was wondering if i could lower the car just .5 to an inch. i know that most allow you to lower it 1.6 or so inches, but i dont want it to be that low...is there anything i can do?

Thanks for your imput

[WJN333]

The 1.5-2 inch drop is accomplished with the Tein S-techs, or the Eibachs for our cars. There has been some experimentation with Camry Tein H-techs to see if they would fit for supposidly a 1 inch drop. But to drop only .5 of an inch you are probably looking at coil-overs. Then you can adjust the height to whatever you want, at any particular time. Be sure to search, you might get flamed on this one.

Hope that helps

[WTF??]

^hahahahahahahhaahaha

[Mole]

get bigger subs.

[SolaraBlue]

you might want to look into tein h-techs