Gauging Interest In Flywheels and Pulleys

[StockSolara]

i am interested in 3 sets od the accesory pullies as soon as you can get them made.

Me too. . . Pullies for the Alternator, Water Pump, and Power steering would be nice

[Sportivo Concepts]

You guys do know that you will have minuim power gains with the pullies located there, especially with the Gen 1s.

I have a rough estimate of the prices for the Crank Pulley and flywheel.

Flywheels
$550 Shipped to your door all 50 states.
Crank Pulley
$200 (shipped to your door all 50 states)

If you guys really want all 3 pulleys the cost will be a little higher, and will take a little more time to fabricate since we do not have the specs on them

[JavaJoe_2]

Do you happen to have picture's of previously parts you have developed?
Colors or would they have a polished or machined finish?
The pulley's that is, I know the flywheel would be machined finish.

[DaTwUnKrAziEpInOy]

$200 sounds pretty good for the crank pulley

[SleeperSolara]

$200 sounds pretty good for the crank pulley

True that.

[Sportivo Concepts]

Would you guys consider this viable then?

Or would you really want the 3 set pulleys (even if the other two does not make much of a difference)?

[StockSolara]

Would you guys consider this viable then?

Or would you really want the 3 set pulleys (even if the other two does not make much of a difference)?

I am thinking in the mind of someone that is S/C since the blower is added it does add restriction to pulling belt. . . So anything to just make it spin much easier would help in the lost of power through heavier pullies. . . I am interested in the other 3 pullies but I don't know if anyone else is