ToyoSolV6 wrote:
exactly where did you cut bro??, because ur right mine is sort of at an angle and it annoys me at times
btw are you on springs still or back on your coils?
What i did was measure the corner of the lip and ran a ruler with a pencil to the side of the lip. I wanted the same height in the front in the side of the lip. I cut off the red part in the picture below. I still got to cut a little more in the center of the red line so that the lip would sit more flush.

The car is on Teins all around, no coils. I made sure i got a full tank of gas before so the rear is lower. haha


-
Toy1mzfe - SolaraGuy Street Racer
- Posts: 1400
- Joined: Mon Jan 15, 2007 2:04 am
- Location: San Francisco (415)