Ok. I e-mailed them and here is what they say. There hold time is ridiculous!!! They did read this thread...
Joe is right about the sacrifice you have to do to use this with complete success. You would have to finish all the modifications you plan on doing and then have it custom made to fit your specs. Otherwise you would need re-flash and what not and can be costly...Here is what they said about that...
For the record..I intend on sticking with what comes with the supercharger kit designed for the 5S-FE...and don't intend on going with JET's product. Otherwise I would get it if I were to stay N/A and complete my engine mods. I'm just trying to get information correct and put the facts straight.
•RIPP Black Box Preprogrammed (Fuel and timing controller no out side tuning required at all)
•RIPP 2 Bar MAP Sensor for exact ECU boost communication
As far as the 1MZ-FE goes... You can get the ECU reprogrammed for your specification from JET; however, keep in mind that you can't alter it unless redone all over again or reflashed as Joe stated. So it's pretty much up to you and how deep your pockets can go. An added benefit is that they can also remove your top speed limiter along with the other things they do to your ECU. Shoot if it cost $400 - $500 they better do all they can.
It's good that this has been discussed because there has been some confusion and this thread can house all pro's and cons with various ECU alterations. It would be nice to get Greg's input on this since he does have a JET application on his Solara S/C 1mz.

"Not the case. Assuming the "chip" is not erasable or re writable, how is it
that the dealer reflashes the IN HOUSE??"
Joe is right about the sacrifice you have to do to use this with complete success. You would have to finish all the modifications you plan on doing and then have it custom made to fit your specs. Otherwise you would need re-flash and what not and can be costly...Here is what they said about that...
http://www.jetchip.com/DynoSheets/2000%20Camry%202.2L.PDF
You may need a newer version of Adobe acrobat.
. The ecu upgrades are all done per the application, in other words, do all the modifications you intend on doing before you get the ecu upgraded. That way the program can be set up for the specific modifications. Hp gains would be dependant on the extent of modifications.
For the record..I intend on sticking with what comes with the supercharger kit designed for the 5S-FE...and don't intend on going with JET's product. Otherwise I would get it if I were to stay N/A and complete my engine mods. I'm just trying to get information correct and put the facts straight.
•RIPP Black Box Preprogrammed (Fuel and timing controller no out side tuning required at all)
•RIPP 2 Bar MAP Sensor for exact ECU boost communication
As far as the 1MZ-FE goes... You can get the ECU reprogrammed for your specification from JET; however, keep in mind that you can't alter it unless redone all over again or reflashed as Joe stated. So it's pretty much up to you and how deep your pockets can go. An added benefit is that they can also remove your top speed limiter along with the other things they do to your ECU. Shoot if it cost $400 - $500 they better do all they can.


2007 VW GTI
-
SolaraT - Solaraguy need mo power guy
- Posts: 1944
- Joined: Thu Sep 25, 2003 4:49 pm
- Location: ORLANDO, FL