tranny hex bolt!!!!!!!!!!!!!!!!!

by **DrakkkarDarkbladE** » Mon Jan 16, 2006 12:28 pm

How in the world are you supposed to undo that f'in bolt? I have tried everything and it wont even budge even after spraying it with WD-40.

Refrain from using swear words.

by **SC V6** » Mon Jan 16, 2006 1:15 pm

Probably not a Hex bolt... probably a Torx head... which tranny bolt are you referring to?

by **DrakkkarDarkbladE** » Mon Jan 16, 2006 2:09 pm

the one on the bottom of the pan that releases the oil....

by **SleeperSolara** » Mon Jan 16, 2006 2:57 pm

I think it is a 10mm or 12mm hex bolt socket.
If it don't come out you need to use a breaker bar, that will work.
Mine was kind-of hard, but i got it off though.

by **bassthrive** » Mon Jan 16, 2006 3:22 pm

An allen key and your hand just wont work. Definitely need a breaker bar.

by **SC V6** » Mon Jan 16, 2006 4:55 pm

definitally thought you were talking about disassemblying a tranny... which is why I thought it was a torx.. anyway.. its an allen key... probably just tight because of the constant heating up and cooling of the tranny... just put some muscle into it, and make sure you going the right direction

by **DrakkkarDarkbladE** » Tue Jan 17, 2006 12:17 pm

Got it off today finally. Leaked out about 4 quarts. Will do again in week then take down the pan in another week, and change the strainer and the gasket and its Royal Purple MAX ATF then.

tranny hex bolt!!!!!!!!!!!!!!!!!

tranny hex bolt!!!!!!!!!!!!!!!!!

Who is online